Group Spent Time Finalizing Report which was submitted to Dr. Ejaz on Wednesday. Happy Thanksgiving All!

Wrote sections 2.5, 3.3, 3.4, 3.5, and 4.1 of report. Section 2.5 contains Prototype Testing Data, Sections 3.3 to 3.5 deal with Health &...

Members of the Team began on individual sections of Chapter 3 and 4 in order to bring a final draft to Dr. Ejaz for review and feedback....

This week, Ian wrote sections 1.5, 3.1, 3.2, and 4.2 of the report and created the Table of Contents, List of Figures, and List of Tables....

Wrote Sections 2.3 and 2.4 of the Proposal Report.

Members of the Team began on individual sections of Chapter 2 in order to bring a draft to Dr. Ejaz for review and feedback. Changes to...

After reviewing the fan control diagram, it became clear that the limited number of GPIO on the MCU would make it very complicated and...

Following feedback from Dr. Allen Jones of the IEEE, the group set out to rewrite the report submitted initially to the IEEE as well as...

The main objectives for the week were to finalize the design as a proof of concept and to write the Abstract and Chapter 1 of the...

After reviewing the feedback brought forward to us by Allen Jones from the IEEE and the group decided to use a higher capacity solar...

Following the testing on Saturday and Sunday, methods of supplying power to the system were devised and a compromise between solar power...

After testing on Saturday and Sunday, charts were created using the test data. These can be seen on the Google Sheet along with all the...

Group Re-Tested Crossflow Ventilation methods against a reference vehicle which had no ventilation and set out to determine which of the...

Introduction : Discussed during our meetings related to Project A.S.H.E. is the unknown effectiveness of the proposed method of optimized...

Objective The objective of this report is to determine the best method for directing airflow through a parked car using ventilation fans....

Given the redesign of our system, efforts were undertaken to rewrite our software block diagram and brainstorm a block diagram for a...

Since the test results did not lean in the Peltier device's favor, the cooling method was scrapped in favor of ventilation. Earlier in...

Prior to the experimentation on Sunday, Ian researched a method to automatically take voltage and current measurements for the solar...

Throughout the week, some testing on the Tiny Heat Exchange System was performed with initial results being promising if and only if the...

While developing the Engineering Specifications sheet, it became clear that an appropriately rated solar panel would be essential to the...